To check consumed hardware resources in VMware vSphere Client, select a virtual machine, open the Monitor tab, and then select Performance > Overview or Performance > Advanced to view charts and other information. I wanted to do a fresh install of workstation pro 16 but when i did When I start up Ubuntu under Vista host. Wake on LAN allows you to power on the nuc remotely, which is also very helpful. VMware Tools must be installed on a guest OS for VM performance monitoring. Security > Security Features: Intel Platform Trust Technology: Disabledĭo not change power policies, they can be configured from the ESXi itself, which is much more comfortable and possible without a reboot.
ONTAP tools for VMware vSphere is a set of tools for using ONTAP storage. Security > Security Features: Intel VT for Directed I/O (VT-d): Enabled* datastores and vVols within the ONTAP cluster to balance performance and.Security > Security Features: Intel Virtualization Technology: Enabled*.To get rid of TPM 2.0 error mesages ("TPM 2.0 device detected but a connection cannot be established.") disable Intel PTT. Performance > Prozessor > Active Processor Cores: All*Īctivate both virtualization features VT-x and VT-d.Performance > Prozessor > Intel Turbo Boost Technology: Enabled*.Performance > Prozessor > Hyper-Threading: Enabled*.When noise is not a problem configure it to "cool", which is the best mode for reliability.įor maximal performance, make sure that HT, Turbo Boost and all cores are enabled. If you need the NUC to be as silent as possible, configure the Fan Control Mode to "Silent". The cooling configuration depends on your situation. Advanced > Onboard Devices > HDMI CEC Control: Disabled.Advanced > Onboard Devices > Enhanced Consumer IR: Disabled.Advanced > Onboard Devices > SDCard 3.0 Controller: Disabled.Advanced > Onboard Devices > Bluetooth: Disabled.Advanced > Onboard Devices > WLAN: Disabled.Advanced > Onboard Devices > Thunderbolt Support: Enabled*.Advanced > Onboard Devices > LAN: Enabled*.Advanced > Onboard Devices > Digital Microphone: Disabled.Advanced > Onboard Devices > HD Audio: Disabled.I recommend disabling everything except the onboard NIC and Thunderbolt support. It's a good practice to disable all unused devices. To enter the BIOS, press F2 after powering on the system. Available options may differ with older NUCs. The list was created based on the latest 10th Gen Frost Canyon. The following BIOS settings are recommended for Intel NUC Systems running VMware ESXi.